
Mechanical Process Engineer - Water
- Mumbai, Maharashtra
- Contract
- Full-time
Conceptual design, Preliminary Design Report, P&ID, Layout and Specification development.
Vendor Pre-Bid Engineering - Equipment & commodities RFP preparation, bid clarification and bid evaluation.
Vendor Post Bid Engineering - Review of documents and approval, coordination with Vendor and internal team, site coordination for technical queries.
Shall have experience or familiarity on water and wastewater systems, typical systems which we are looking to perform design & engineering worked above in point 1 to 4 are listed below, candidate may not have exposure to all but open learn and understand quickly would be preferred:
Pumping systems (water, sewage, wastewater, sludge, and sea water)
Water Treatment Plant
Wastewater Treatment Plant
Screening System
Aeration blowers, BNR Basins Diffusers and control valves
Bridge Cranes, monorail hoist
Compresses Air system.
Engine Generator and diesel fuel storage tank
Boilers, Heat Exchangers and Heating Water Piping
Digester Mixing, Gas Piping, Membrane Gas Holders & Waste Gas Burners
Screw Conveyors, Thickeners, Centrifuges
Odor Control System
Microfiltration, Ultrafiltration and Reverse OsmosisEngineering Standards:
Continues to learn, remains current and applies independent knowledge and interpretation about departmental design guides, standards, systems, applicable engineering codes and Black and Veatch policies and procedures relative to assigned tasks
Quality/Continuous Improvement:
Consistently and independently applies knowledge and complies with Black and Veatch quality program relative to assigned tasks
May be responsible for ensuring compliance with Black and Veatch quality program
Provides guidance and direction to others from the same project and discipline
Supports continuous improvement and change management efforts
Engineering Production:
Prepares a variety of complex engineering deliverables
Performs complex research and develops recommendations for equipment and/or materials selection
Prepares complex engineering calculations following standard methods and principles
Manages assigned budget, schedule, and quality requirements
Plans and conducts independent evaluation, selection and adaptation of engineering techniques, procedures and criteria
Reviews lower level engineering work or assignments
Is responsible for one or more of the following:
overseeing collection, assimilation, and management of data for engineering work; leading smaller production teams; and serving as the responsible charge for a project#LI-AP1Management ResponsibilitiesPreferred Qualifications
- Written Communications
- Drive For Results
- Priority Setting
- Planning
- Delegation
- Directing Others
- Conflict Management
- Informing
- Listening
- Dealing with Ambiguity and Building Effective Teams
- Intermediate knowledge of engineering design principles and applicable design guides and standards related to assigned engineering discipline